Separate names with a comma.
Engine died RIP
No haynes manual, however the resources section on this site has some manuals. 1.3l engine manual: Daihatsu Type K3 Engine Service Manual I'd...
The only electronic beep I know about when the Copen is moving is when the roof is ajar or roof latches aren't closed. I once set off before the...
I'm using TR1 and they are doing well for me. A good replacement for the factory Bridgestone RE040. Only downside is they aren't (or weren't)...
Just thought I should share my excel spreadsheet here too since it has the gear ratios and speed and such for every copen calculated...
I did some maths and based on the gear ratio and tire size, at 60mph (26.8224 m/s) the engine speed should be 3724.481296 rpm. (3.7 x1000) A UK...
Doesn't seem normal, my Copen doesn't do that. Is this only when the engine is *not* running? (now thinking about it, I've never operated the...
I'm pretty sure the exterior body panels are identical between the 660 and 1.3l, but in case they aren't you can order parts from an ex-dealer,...
It is possible to get new panels but they will be made to order and shipped from japan. I did this a couple years ago (2020) I ordered them...
Didn't think they sold the autos in the uk so I suspect it is an import. If so there may be more unexpected differences. I'm pretty sure the...
from those photos you will need bumper, wheel arch lining, tail light, turn signal, and maybe rear quarter panel if it cant be straightened out....
How much it's going to cost depends on how deep it goes and the only way to really know is to remove the paint I had rust on my copen and it went...
The copen has no isofix for a car seat and the passenger airbag cannot be turned off so it probably isn't recommended to have a young child/baby...
I was planning on getting those but before I could buy they were no longer available anywhere in the UK Where in Switzerland are they available so...
my first filter change took a long time also as I had the exact same problem. luckily once the correct filter is in it becomes a much quicker...
Wouldn't the roll bar be the best place? It is a structural part of the car so it should be strong enough. Will need to remove some interior trim...
I know it's late but I think I have found the coefficient of drag for the L880 Copen. I did a bunch of maths and made some estimates to find what...
There is nothing to bleed as the clutch is cable operated, not hydraulic. If it's only 1st and 2nd I doubt its a clutch problem as I'd expect that...
In the Resources section Here: Resources | Copenworld account needs to be 7 days old if I remember right.
because the rear is non independent torsion beam, there is no camber adjustment, however there is something called a camber plate/shim which is a...
