Separate names with a comma.
Hi Staimee Which engine are you referring to? Have all the plugs failed their test?
Hi Hugo I might be able to help you depending on the make of key fob e.g. attached Regards [ATTACH]
Hi Bisco, ‘Tail and stop lamp bulb’ ‘Removal and installation’, as you are Copenworld newbie and cannot access the full site yet. ‘Resources’...
Hi Norman Sills can be replaced by going to a sheet metal jobbing shop/factory with a metal profile of your sill. Preferably make this of wire...
Hi Kisobush321 Drivers side wiper blade 46cm and passenger side wiper blade is 41cm and the passenger side has the longer arm. Hope this sorts it out.
Hi had a stainless steel exhaust fitted a couple of years ago and time to clear out the garage! This original exhaust runs from the lower sensor...
Hi Kit In the first instance did you take the car to the garage with a misfire? If you did and they diagnosed that the first O2 number 1 sensor...
Hi our Copen is only used for a few months in the summer. It has a Bosch battery made in Spain. S4 018 40Ah 12V. This is the replacement one put...
Hi Kit, sorry to hear about your problems. In your message you omit to let us know what engine size your car has and you say you have everything...
Yes it can be.
Hi Guzziman and his wife were told by the previous owner that the only way they would sell it to us was that the cars name be kept hence DTM is...
Hi Marcushnz Yes, I can confirm that the level should be where the pencil mark is with the roof in its’ closed position. If it is at that mark it...
Hi Rich Please see photo, info in ‘service manual 9842’ page B8-8 & page B8-145 part no is 25860-97205 and other number 136200-2960, 12 volt...
Hi Tictac I would not drive the car anymore but I would take out chain tensioner plunger. Do not move the engine after removal as it will affect...
Hi Tictac Before you take the tensioner out it would be prudent to change the engine oil and maybe do a flush as the chain tension plunger relies...
Hi Just measured the gaps with a Vernier and the varying widths all-round the screen are between 3.5 mm to 4 mm. The depth of the gap is a...
Hi On seeing your pictures it looks like they may have rushed it a bit because in the manual you have to remove the top cowl ventilator louver...
Hi David Another check is if there is a leak in the vacuum pipe going into the servo. If all is OK, then the servo can be serviced and will...
Hi David First try changing all of the brake fluid and if there is still a problem the servo unit is your next step provided you haven’t a leak...
Hi Michael There are people in the UK that specialise in the rebuilding of shock absorbers for unusual cars, racing spec etc. to customer...
