Separate names with a comma.
Sorry for the delay been snowed under at work. In the end I didn't need a Condenser so I don't know the part number as the dealer declined to...
Hi, For information for the community. The Condenser is a Daihatsu part, specific to the Copen 1.3 and only available from Japan at ~ £500.
Yes. It's the same as the already in the resources section.
I think others on the forum have fitted the left hand drive ones and said there is no difference between the 2: Clutch Cable replacement. What a...
I thought it was a dash out job too, which is why i didn't do it. The invoice says 1. 7 hours labour though. I think i saw a thread on here...
Congratulations! Looks like a nice tidy one and nice low mileage! They are a fun little car and generally easy to work on. Copenworld and the...
Hi, I've driven a couple of Copen's (both with new clutches) and the biting point on both was really low. Not an issue for driving or selecting...
The cable itself is around £80 (OEM part). I don't think the genuine part is more expensive but may need to come from Japan and some garages...
The code for the blank key blades is DH4R btw.
Does it have an alarm already? My life was made a lot easier by getting hold of the wiring diagram for the(malfunctioninig) alarm I already had...
Hi CheekySusie, I have had dealings with Timpsons and I think there are threads on here discussing them. I found them to be expensive, not very...
Looks about right to me and my needle sit there too. Note that where you are saying the needle sits is actually midway between cold and hot.
Hi, I have a leaking air conditioning condenser and wish to replace it. Does anyone know the part number or whether it is actually a Toyota...
I seem to remember UK Suzuki Cappucinos were speed limited.
Glad you found some. Looking good.
Free stuff is by far the best stuff
Glad you like them. White always look good. The red was a gamble. Hope the op goes OK. I can confirm for anyone who is concerned about doing...
They look good. I could have done with this 7 months ago when I was after some custom dials. Lockwood weren't interested in/able to do a single...
Sorted now. The wires from the boot latch to the switch seen to be at 12v and going to ground via the boot release switch (thanks wiring...
Hi Ronaldoes, I have contacted the Copen World founder and and shared it with him with a view to him putting it on the site. I am more than...
